Ask a Question
How the phase balancing is done by My Ecodial L during the power calculation.
Consider a network having a source (400 Volts) and three single phase loads (each of 10 Amps)
During the power sum, Ecodial sizes the source requirement – based on the loads and their distribution.
By default, Ecodial considers the phase balancing…
As shown here,
These three single phase loads are equally connected on 3 different phases and to the neutral.
User can also change the load distribution…and verify the source sizing.
And user can come back to the automatic phase balancing by clicking the “check box” in the power sum
Was this helpful?
What can we do to improve the information ?
Not the FAQ you were looking for? Click here for a new search